My bad. See
Jesper's post.
I did not see
that you are using the VPN client.
I need to where
my glasses more.
What I posted
applies to unit to unit VPN.
John Tolmachoff
MCSE, CSSA
IT Manager,
Network Engineer
RelianceSoft,
Inc.
Fullerton,
CA
92835
www.reliancesoft.com
-----Original
Message-----
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Lance Loudan @
Benedict
Sent:
Tuesday, December 17,
2002 6:33
AM
To: '[EMAIL PROTECTED]'
Subject: RE: [SonicWALL]- Problem
forwarding packets
OK, I
have done that, my question is what is Spoke 1 is the VPN client setup in
Advanced mode. Do I need to setup another connection with the
different subnet on it. I am asking this because I tried this and it
still is not working. Do I also have to add the VPN internal IP
address to Spoke 2.
-----Original
Message-----
From: John
Tolmachoff [mailto:[EMAIL PROTECTED]]
Sent: Monday, December
16, 2002 4:13
PM
To: [EMAIL PROTECTED]
Subject: RE: [SonicWALL]- Problem
forwarding packets
On each "spoke"
of the wheel, you have to define the other remote networks (other spokes)
under the networks listed in the SA properties page.
Example:
Hub network is
10.0.0.0/24
Spoke1 is
10.0.1.0/24
Spoke2 is
10.0.2.0/24
Spoke3 is
10.0.3.0/24
You want Spoke
1 to have access to Spoke2.
On the SA
properties of Spoke 1, you have a destination network specified of
10.0.0.0/24
You need to add
a specified destination network of 10.0.2.0/24.
Now, the
Sonicwall will know that anything destined for 10.0.2.0/24 is to be sent
through the VPN to the hub Sonicwall, which will then forward it via the
appropriate SA to that network.
John Tolmachoff
MCSE, CSSA
IT Manager,
Network Engineer
RelianceSoft,
Inc.
Fullerton,
CA
92835
www.reliancesoft.com
-----Original
Message-----
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Lance Loudan @
Benedict
Sent:
Monday, December 16,
2002 11:54 AM
To: SonicWall User Forum
(E-mail)
Subject:
[SonicWALL]- Problem forwarding packets
I
have set up my VPN client as set forth in the advance instructions
supplied from Sonicwall. I have that working fine and can connect to
the firewall, my problem is that it is not forwarding to remote
VPNs. Do I need to setup a client for each new subnet and route it
through the same firewall. I guess my question is what tells the
firewall to route the packets. I have checked the route table and
the remote VPN are not listed in it but I have SAs setup for all of
them. Do I still need to add them to the routing table? The
routes that I did add to the routing table are still not working
either. I could use some help please.
