-----Original
Message-----
From: John Tolmachoff
[mailto:[EMAIL PROTECTED]]
Sent: 17. december 2002 16:12
To: [EMAIL PROTECTED]
Subject: RE: [SonicWALL]- Problem
forwarding packets
My
bad. See Jesper’s post.
I
did not see that you are using the VPN client.
I
need to where my glasses more.
What
I posted applies to unit to unit VPN.
John
Tolmachoff MCSE, CSSA
IT
Manager, Network Engineer
RelianceSoft,
Inc.
Fullerton,
CA 92835
www.reliancesoft.com
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]] On Behalf
Of Lance Loudan @ Benedict
Sent: Tuesday, December 17, 2002
6:33 AM
To: '[EMAIL PROTECTED]'
Subject: RE: [SonicWALL]- Problem
forwarding packets
OK, I
have done that, my question is what is Spoke 1 is the VPN client setup in
Advanced mode. Do I need to setup another connection with the different
subnet on it. I am asking this because I tried this and it still is not
working. Do I also have to add the VPN internal IP address to Spoke 2.
-----Original
Message-----
From: John Tolmachoff
[mailto:[EMAIL PROTECTED]]
Sent: Monday, December 16, 2002
4:13 PM
To: [EMAIL PROTECTED]
Subject: RE: [SonicWALL]- Problem
forwarding packets
On
each "spoke" of the wheel, you have to define the other remote
networks (other spokes) under the networks listed in the SA properties page.
Example:
Hub
network is 10.0.0.0/24
Spoke1
is 10.0.1.0/24
Spoke2
is 10.0.2.0/24
Spoke3
is 10.0.3.0/24
You
want Spoke 1 to have access to Spoke2.
On
the SA properties of Spoke 1, you have a destination network specified of
10.0.0.0/24
You
need to add a specified destination network of 10.0.2.0/24.
Now,
the Sonicwall will know that anything destined for 10.0.2.0/24 is to be sent
through the VPN to the hub Sonicwall, which will then forward it via the appropriate
SA to that network.
John
Tolmachoff MCSE, CSSA
IT
Manager, Network Engineer
RelianceSoft,
Inc.
Fullerton,
CA 92835
www.reliancesoft.com
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]] On Behalf
Of Lance Loudan @ Benedict
Sent: Monday, December 16, 2002
11:54 AM
To: SonicWall User Forum (E-mail)
Subject: [SonicWALL]- Problem
forwarding packets
I have
set up my VPN client as set forth in the advance instructions supplied from
Sonicwall. I have that working fine and can connect to the firewall, my
problem is that it is not forwarding to remote VPNs. Do I need to setup a
client for each new subnet and route it through the same firewall. I
guess my question is what tells the firewall to route the packets. I have
checked the route table and the remote VPN are not listed in it but I have SAs
setup for all of them. Do I still need to add them to the routing
table? The routes that I did add to the routing table are still not
working either. I could use some help please.
