Each side of each trunnion has TWO sheet metal washers! One goes between the lip of the plastic bushing and the trunnion, and the other goes over the lip. Their raised edges face each other, and sort of overlap. When you press the plastic pieces into the trunnion, you have to put them through the inner washer first. The square-section O-ring goes just outside of the edge of the lip, between the two washers. (It makes more sense when you see it for real.)
The tricky part is holding everything together as you insert the trunnion, the two outer washers, and the two O-rings into the A-arm without messing them up... There is actually not a whole lot of empty space when everything is assembled. I just smeared grease all over everything. Some extra grease helps hold the O-rings and washers in place during assembly. Doug Braun '72 Spit At 07:40 PM 10/24/02 -0700, Dan Canaan wrote: >At 10:13 PM 10/24/02 -0400, Jack wrote: >>Hoping to pick someone's brain who has replaced the trunnion bushings. I'm >>about to tackle that. I've got the parts and have sort of "dry fit" them on >>the kitchen table. I am concerned about exactly what to do w/ the rubber >>seals. The Haynes manual just says "fit them." Are they to be fit around the >>flange of the nylon bushings or what? >>I'm also puzzled because I expected there to be a hunk of rubber w/ this >>stuff...something that fits inside the trunnion housing and around the >>trunnion bolt. The manual seems to say that this area is just filled w/ >>grease. Is that right? > > >The bushings are fitted horizontally with the nylon insert into the >trunnion, then the rubber oil seal fitted to the flange on the nylon, and >finally the metal washer on top of that. Unless you have the entire lower >control arm to fit the completed trunnion bushing together out and sitting >on the table as well, it's not a job for the bench. Assembling them before >that will just have the bushings and oil rings falling out a lot. > >Assembly is done at the time you are putting the trunnions back onto the >control arm. /// [EMAIL PROTECTED] mailing list /// Send admin requests to [EMAIL PROTECTED] /// or try http://www.team.net/cgi-bin/majorcool /// Archives at http://www.team.net/archive /// Send list postings to [EMAIL PROTECTED] /// Edit your replies! If they include this trailer, they will NOT be sent.
