Now that I have the Canley Classics CV joint-axels in, I cranked on the rear hubs. When I added the road wheels to the frame (to get the rolling chassis really "rolling") if find that for some reasons none of the wheel studs will tighten, the threads are too small. I need to replace the wheel studs at this point for both of the rear axles. However, how does one actually remove the wheel studs on a hub that is already installed? I have a Churchill tool, but if the studs are so buggered up that they won't hold a tire on, I'm sure that the Churchill Hub Puller (also from Canley Classics) won't do the trick. Is there a special tool or technique? I tried to hammer the stud to no avail.
TIA Dan Parrott Savannah, Ga 1980 Triumph Spitfire "PJ" 1972/1978 Spit Six Project car "Joseph" _______________________________________________ Support Team.Net http://www.team.net/donate.html You are subscribed as [email protected] [email protected] http://autox.team.net/mailman/listinfo/spitfires http://www.team.net/archive
