Friends,

The current issue of Live Steam and Outdoor Railroading magazine (Jan-Feb 
2007) has an in-depth article by Kozo Hiraoka about the design and 
fabriaction of safety valves.  The techniques he describes are directly 
applicable to making clack/check valves.  In particular, he provides 
information about how to size the valve (ball) relative to the diameter of 
the steam passage (for a cladk this would be the water passage) and how to 
seat the ball to make a tight seal.

V/r,

Casey Sterbenz
O Scale Kings #8

>From: Harry Wade <[EMAIL PROTECTED]>
>Reply-To: Small-scale live steam discussions <[email protected]>
>To: Small-scale live steam discussions <[email protected]>
>Subject: Re: [SSLiveSteam] New lathe - second project
>Date: Wed, 03 Jan 2007 09:21:53 -0600
>
>At 09:43 AM 1/3/07 -0500, you wrote:
> >For my second project I'd like to attempt to build a clack valve to
> >attach to the backhead fitting of my C-16. First I will need to learn
> >how to use my lathe to cut threads (M5x0.5), that might take some time.
>
>David,
>      Clack/check valves are perhaps the most basic and often made fitting
>and have been described in a virtually every locomotive construction
>article ever published and most of them follow the same pattern; they use a
>captive stainless steel, bronze, or nitrile (hard rubber) ball.  Rarely
>does anyone bother with anything else until you reach 7+ga and even then
>balls are the majority first choice.
<snip>
>
>Regards,
>Harry Wade
>Nashville  Tennessee

_________________________________________________________________
Your Hotmail address already works to sign into Windows Live Messenger! Get 
it now 
http://clk.atdmt.com/MSN/go/msnnkwme0020000001msn/direct/01/?href=http://get.live.com/messenger/overview

_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to