In a message dated 1/3/2007 6:44:40 A.M. Pacific Standard Time,  
[EMAIL PROTECTED] writes:

The  question is the clack valve body. Most of the stuff I've seen (full
scale)  is a type of swing valve or flap valve. I'm guessing I should be
able to  use a stainless ball and spring. Is this a good guess? Or do I
need some  type of plunger? Any suggestions? Anyone have drawings or
plans I might be  able to adapt?



On boiler feed check valves (angle valves) I found it easier to make the  
body as a plain cylinder with the outlet silver soldered in. After the side  
discharge is soldered in then tap the top and bottom (1/4 X 40 in my case) then 
 
you can screw in the seat and the cap. This avoids the problem of finishing up 
a  good ball seat down inside the valve body. Harry was right the seat must be 
 reamed as a twist drill will never make a good round hole for the ball seat. 
 Doing it this way avoids the need for special bottoming taps as the critical 
 threads on both the cap and the valve seat are OD threads. You can thread 
the  cap and seat with your normal die, then turn the die over and run the 
threads  right to the shoulder. There is no need to cut threads in the lathe to 
make  these valves. (Pretty hard to cut an internal thread in our small sizes 
and 
 right to a shoulder. 
Then use your 'seat forming ball' and whack the ball into the seat, but  save 
that ball for forming seats as it will never seal as a valve after the  
"whack" with the hammer. Most beginners allow too much rise for the ball to 
make  
an effective check valve. Look at the area of the annular opening that just a  
small lift will allow. Leave a protrusion on the cap to limit the lift to just 
 pass the amount of water or steam involved. 
That nitrile (spelling?) sounds interesting as after a long lay up check  
valves seem to attract scale and when something like a check on a between the  
frames feed pump will be the one that is fouled. 
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
http://postfix.45mm.com/pipermail/sslivesteam/attachments/20070103/2d974d22/attachment.html
_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to