Has anyone else had trouble getting the hba to "configure?"
hw - v210
hba qla2460
from the OK prompt - test-all shows the hba
fcinfo hba-port
HBA Port WWN: 210000e08b8a7f75
OS Device Name: /dev/cfg/c3
Manufacturer: QLogic Corp.
Model: QLA2460
Firmware Version: 4.0.27
FCode/BIOS Version: QLA2460 Host Adapter Driver(SPARC): 1.11 10/03/05
Type: N-port
State: online
Supported Speeds: 1Gb 2Gb 4Gb
Current Speed: 4Gb
Node WWN: 200000e08b8a7f75
luxadm -e port
/devices/[EMAIL PROTECTED],700000/SUNW,[EMAIL PROTECTED]/[EMAIL
PROTECTED],0:devctl NOT CONNECTED
cfgadm -al
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 CD-ROM connected configured unknown
c1 scsi-bus connected configured unknown
c1::dsk/c1t0d0 disk connected configured unknown
c1::dsk/c1t1d0 disk connected configured unknown
c2 scsi-bus connected unconfigured unknown
c3 fc-fabric connected unconfigured unknown
cfgadm -c configure c3
bash-3.00# cfgadm -al
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 CD-ROM connected configured unknown
c1 scsi-bus connected configured unknown
c1::dsk/c1t0d0 disk connected configured unknown
c1::dsk/c1t1d0 disk connected configured unknown
c2 scsi-bus connected unconfigured unknown
c3 fc-fabric connected unconfigured unknown
from the McData switch, I can see the WWN for the v210, status is good, but I
can't seem to get the cfgadm to configure the hba? The other side of the
McData is a SAN with LUNs configured. No zoning or masking.
--Geff
This message posted from opensolaris.org
_______________________________________________
storage-discuss mailing list
[email protected]
http://mail.opensolaris.org/mailman/listinfo/storage-discuss
