Hi Geff,

http://src.opensolaris.org/source/xref/nwsc/src/sun_nws/pkgdefs/SUNWqlc/postinstall

The QLA2460 does not get an entry into the driver_aliases or other 
driver files.


G Lampshire wrote:
> Has anyone else had trouble getting the hba to "configure?"
>
> hw - v210
> hba qla2460
>
> from the OK prompt - test-all shows the hba
> fcinfo hba-port
> HBA Port WWN: 210000e08b8a7f75
>         OS Device Name: /dev/cfg/c3
>         Manufacturer: QLogic Corp.
>         Model: QLA2460
>         Firmware Version: 4.0.27
>         FCode/BIOS Version: QLA2460 Host Adapter Driver(SPARC): 1.11 10/03/05
>         Type: N-port
>         State: online
>         Supported Speeds: 1Gb 2Gb 4Gb 
>         Current Speed: 4Gb 
>         Node WWN: 200000e08b8a7f75
>
> luxadm -e port
> /devices/[EMAIL PROTECTED],700000/SUNW,[EMAIL PROTECTED]/[EMAIL 
> PROTECTED],0:devctl                    NOT CONNECTED
>
> cfgadm -al
> Ap_Id                          Type         Receptacle   Occupant     
> Condition
> c0                             scsi-bus     connected    configured   unknown
> c0::dsk/c0t0d0                 CD-ROM       connected    configured   unknown
> c1                             scsi-bus     connected    configured   unknown
> c1::dsk/c1t0d0                 disk         connected    configured   unknown
> c1::dsk/c1t1d0                 disk         connected    configured   unknown
> c2                             scsi-bus     connected    unconfigured unknown
> c3                             fc-fabric    connected    unconfigured unknown
>
> cfgadm -c configure c3
> bash-3.00# cfgadm -al
> Ap_Id                          Type         Receptacle   Occupant     
> Condition
> c0                             scsi-bus     connected    configured   unknown
> c0::dsk/c0t0d0                 CD-ROM       connected    configured   unknown
> c1                             scsi-bus     connected    configured   unknown
> c1::dsk/c1t0d0                 disk         connected    configured   unknown
> c1::dsk/c1t1d0                 disk         connected    configured   unknown
> c2                             scsi-bus     connected    unconfigured unknown
> c3                             fc-fabric    connected    unconfigured unknown
>
> from the McData switch, I can see the WWN for the v210, status is good, but I 
> can't seem to get the cfgadm to configure the hba?  The other side of the 
> McData is a SAN with LUNs configured.  No zoning or masking.
>
> --Geff
>  
>  
> This message posted from opensolaris.org
> _______________________________________________
> storage-discuss mailing list
> [email protected]
> http://mail.opensolaris.org/mailman/listinfo/storage-discuss
>   
_______________________________________________
storage-discuss mailing list
[email protected]
http://mail.opensolaris.org/mailman/listinfo/storage-discuss

Reply via email to