On 04 Jun 2014, at 17:01, Dirk Hohndel <[email protected]> wrote: > On Wed, Jun 04, 2014 at 04:54:22PM +0200, Joakim Bygdell wrote: >>>>>> 2# Unused gas mixes are still used in the planned dive resulting in zero >>>>>> consumption issues and extra gas switch events. >>>>> >>>>> That sounds wrong. I don't see how this could be happening. >>>>> >>>>> Can you send step by step instructions how to reproduce this? >>>> >>>> Select dive with unused gases. >>>> Start Planner. >>>> In my case I had AIR as last active gas and a couple of mixes as unused >>>> gases. >>>> >>>> The planner then sets a gas switch at 15min. >>>> And I have al list of gases in the dive plan details that have zero >>>> consumption. >>>> Dirk, this is tested on the dive that I sent earlier. >>> >>> Please try again. >>> >>> These issues does not show up on master. >>> Probably because it where related to the issue above. >> >> On Mac we still have the issue with zero consumption in the finished plan. > > Can you share a fully planned dive that shows this problem? > Is it showing zero consumption for tanks that you don't see? > Or zero consumption for tanks that you do see but that are not used in the > plan?
Seems I was a bit fast here… Latest master works ok on Mac as well. > >>>> Another thing on master is that in Divelist the displayed gas is not the >>>> active gas. >>>> >>>> I will dig into this a bit more. >>> >>> Yes please - and try to explain it better as I'm not sure I understand >>> what you mean. >>> >>> In the Dive list the O2% column does not show the correct value. >>> The dive have AIR as active gas, two EAN mixes and one TX mix as unused. >>> The values displayed in the O2% column shows the values from the TX mix, >>> not the active gas. >> >> This issue is also present on Mac. > > We show the "most interesting" gas in the dive list. So if your dive has > more than one tank we have some made up algorithm of what to show. > To us the most interesting is either the highest fHe or the range of fO2 > on the dive. > So if you have any trimix that you use at any point of the dive, that's > what the dive list will show. > > Is that what you are seeing? Nope, as stated the TX gasmix is unused but it is still shown in the dive list. I have other dives in the dive list that where done on EANx but show up as AIR. I will test redownloading them into a new logbook and see what happens. > > /D _______________________________________________ subsurface mailing list [email protected] http://lists.hohndel.org/cgi-bin/mailman/listinfo/subsurface
