Hi,
Sure I am missing something obvious but I cannot seem to get parms read
by the DTU.
We are using some Sun Ray 1's as information points in the museum,
running various slideshows in kiosk.
Managed to get everything up and running without too much trouble but
they go into Power Off after about 5 minutes.
I've tried everything suggested by reading the various blogs, firmware
updates work fine but it does not read the .parms. Trying to set
poweroff=400 so that I can use crontab to reset everything at 9am and
they will power off when the museum closes at 5pm.
Is there a way of making the DTU just read the .parms?
Thanks
Paul
--
Internal Fire Museum of Power
Tel: 01239 811212
Mob: 07805 538791
Website: http://www.internalfire.com
Facebook:
http://www.facebook.com/pages/Internal-Fire-Museum-Of-Power/198568506925586
ACE/CyMAL Accredited Museum, Registered Charity number 1134971
A member of the Association of Independent Museums.
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
