The other card has a rom labled: Twin Turbo Cemax DB5, Revision 3.8C. It seems to be hard wired to a resolution of 1600x1200, 66 Hz - way out of range of the monitors I have. There are no other resolutions listed as available. When connected with another monitor on the motherboard connector it seems to mirror the other monitor as close as I can tell. There is obviously no dicernable picture but the flickering is in sync with the other monitor when something happens. There are 2 sets of jumper pads near the center of the card labeled JP1 and JP2. JP2 has pins 1 and 2, 7 and 8, and 9 and 10, connected by wires soldered onto the board. The other card has similar pads but has removeable jumpers at 1 and 2 on JP2 and 3 and 4 on JP1. Any suggestions would be most appreciated.
redsilo
--
-- SuperMacs is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics http://www.smalldog.com | Refurbished Drives | Service & Replacement Parts [EMAIL PROTECTED] | & CDRWs on Sale! |
Support Low End Mac <http://lowendmac.com/lists/support.html>
SuperMacs list info: <http://lowendmac.com/supermacs/list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/supermacs%40mail.maclaunch.com/>
---------------------------------------------------------------
The Think Different Store
http://www.ThinkDifferentStore.com ---------------------------------------------------------------
