Hi, To do so we have connected two cables in serial, so we obtained total cable > length 450mm + 450 mm = 900 mm between 359 board and each sensor board.
There's no guarantee this length will work. We try use control page http://192.168.0.9/359/10359_controls.html but it > is not clear which values I have to change. > I'd need to test if it still works fine. A better way to adjust phases is this one: Go to: http://192.168.0.9/ > Parameter Editor > Check "Unsafe" > "View/Edit Current" Or here's a link <http://192.168.0.9/parsedit.php?title=Parameters+for+groups:+unsafe+&CLK_FPGA&CLK_SENSOR&SENSOR_PHASE&I2C_QPERIOD&I2C_BYTES&MULTI_PHASE_SDRAM&MULTI_PHASE1&MULTI_PHASE2&MULTI_PHASE3> . The phases are changed with: SENSOR_PHASE - "system board - MUX" (in stereo setup) MULTI_PHASE1 - "MUX - sensor 1" MULTI_PHASE2 - "MUX - sensor 2" MULTI_PHASE3... bits[18:17] - 90 degree shift bits[15:0] - fine steps (with sign) 0xff01...0x00ff Best regards, Oleg Dzhimiev Electronics Engineer phone: +1 801 783 5555 x124 Elphel, Inc.
_______________________________________________ Support-list mailing list Support-list@support.elphel.com http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
