Hello!
Thank you for fast response!
16.04.2015 21:48, Oleg пишет:
Hi,
To do so we have connected two cables in serial, so we obtained
total cable length 450mm + 450 mm = 900 mm between 359 board and
each sensor board.
There's no guarantee this length will work.
We try use control page http://192.168.0.9/359/10359_controls.html
but it is not clear which values I have to change.
I'd need to test if it still works fine.
A better way to adjust phases is this one:
Go to: http://192.168.0.9/ > Parameter Editor > Check "Unsafe" >
"View/Edit Current"
Or here's a link
<http://192.168.0.9/parsedit.php?title=Parameters+for+groups:+unsafe+&CLK_FPGA&CLK_SENSOR&SENSOR_PHASE&I2C_QPERIOD&I2C_BYTES&MULTI_PHASE_SDRAM&MULTI_PHASE1&MULTI_PHASE2&MULTI_PHASE3>.
The phases are changed with:
SENSOR_PHASE - "system board - MUX" (in stereo setup)
MULTI_PHASE1 - "MUX - sensor 1"
MULTI_PHASE2 - "MUX - sensor 2"
MULTI_PHASE3...
bits[18:17] - 90 degree shift
bits[15:0] - fine steps (with sign) 0xff01...0x00ff
I found that next values are:
SENSOR_PHASE - 0x9
MULTI_PHASE1 - 0x100b0.
Which new values need I to try setup here?
Best regards,
Oleg Dzhimiev
Electronics Engineer
phone: +1 801 783 5555 x124
Elphel, Inc.
--
С уважением, Клещенков Анатолий.
г. Ростов-на-Дону
теп.: +7(863)275-95-05
e-mail: akt...@inbox.ru
_______________________________________________
Support-list mailing list
Support-list@support.elphel.com
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
