> We got a good results with 0x1ff80 value for MULTI_PHASE[n] in both > channels without changing SENSOR_PHASE.
I would measure the range around 0x1ff80 while the image is still good, then set the phase to the middle. For a 450mm cable the working range is ~60-100 steps. At first we get a broken images at same manner. By the way, if we use 450 > mm cable with MULTI_PHASE = 0x1ff80 we get same problem, so MULTI_PHASE is > strongly depends on cable length. > Yes - signal propagation delay. If the experiment will give us a good results we intend to expand a > stereobase for second setup at the same manner. In with case we will order > to you addition cables. > Do you offer now a sensor board (compatible with our 10359) with > monochrome sensor? If so what type of sensor installed into such board? > We do have some monochrome sensor boards. You can buy them but using a monochrome sensor reduces overall resolution of the sensor+lens combination. And most of nowadays the applications deal with color sensors. So, you can: a. Keep using a color sensor - just work with R, G and B channels separately, then combine. b. Get a monochrome sensor - but use a green color band filter in front of the lens to a have better resolution. Best regards, Oleg Dzhimiev Electronics Engineer phone: +1 801 783 5555 x124 Elphel, Inc.
_______________________________________________ Support-list mailing list Support-list@support.elphel.com http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
