On Mon, Mar 30, 2009 at 4:58 PM, Vaughn L. Reid III <[email protected]> wrote: > I have a Intel Atom based board that I'm trying to get pfsense to install > on. I can boot fine into safe mode but I get a panic message when I try the > default boot config. I can reproduce this from both the pfsense ISO and > after an actual install onto the hard drive. I'm trying to install 1.2.3 > (downloaded today). > > I've searched both the forum and the support mailing list archives for > kernel panic, intel atom, bootloader.conf, and mptable_walk_table but didn't > receive any helpful results. A google search of the error message listed > below shows several links that lead to a C programming language file called > mptable.c > > Here's the message: > panic mptable_walk_table: Unknown MP Config Entry 194 > > Here are the board's specs and hardware configuration: > Jetway Manufacturer > Intel Atom dual core 1.6 ghz processor > 2 gigabytes RAM > Sata Drive > 3 realtek 8110 PCI NICs on daughter board > 1 realtek 8119 PCI-Express onboard Nic -- disabled in bios > Onboard Audio -- disabled in bios > ACPI -- disabled in bios > USB 2.0 -- disabled in bios > Floppy Drive -- disabled in bios > SATA Generation 1 -- forced in bios (the hard drive is only 1st generation > hardware, but just to be sure) > > Does anyone have any suggestions that I might find helpful to get this > system to boot the default pfsense? > > Thanks for your assistance.
I recently installed pfSense to my Acer Aspire One Netbook which has the same processor and it works fine. Sorry I could not offer more but it does not seem to be an "Atom" issue. Scott --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
