At 01:12 AM 1/13/00 -0700, you wrote:
>Did you try yanking a UART off one of the com boards then? 50:50 shot, and
>it might just work. Try moving the mouse between the ports then, and see if
>it responds as COM1 or COM2. THEN set the modem as the other.
I am unreasonably timid about such things, ruining a controller card
because I don't know what I'm doing and wind up melting a part of the
circuit board just wouldn't make my day. I'm not really experienced with a
soldering tool and this isn't my machine to destroy. Not sure I'd know a
UART if it jumped up and bit me either.
I'm hoping if I just leave it till I get some answers on the I/O card
driver forum I may luck out on the code for the jumpers. There's been a
few clues here and there, I've just been working outside the home too much
lately to apply them. Life calls me elsewhere.
To unsubscribe from SURVPC send a message to [EMAIL PROTECTED] with
unsubscribe SURVPC in the body of the message.
Also, trim this footer from any quoted replies.
