It was explained to me today by tech support that the CPE can blacklist an eNB if it's unable to connect. They warned me about this possibility when we were talking about site survey procedures. I.E.: if a technician boots up the CPE while it's laying on the ground, it might detect an eNB, fail to connect, then blacklist that eNB. They suggested pointing it in the general direction before powering it up.
I was told it shouldn't happen if you've successfully connected to that eNB previously, but that you do need to reboot to clear the blacklist in the CPE. > Does the Telrad system experience issues where when a CPE is low signal and > disconnects it may find itself blacklisted until the CPE is rebooted? > > If so, is there a way around this so a customer does not have to reboot the > CPE? > _______________________________________________ > Telrad mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/telrad > _______________________________________________ Telrad mailing list [email protected] http://lists.wispa.org/mailman/listinfo/telrad
