Client experiences an issue connecting. Ends up black listed. Has to reboot.
> On Oct 4, 2016, at 21:31, Adam Moffett <[email protected]> wrote: > > I'm not clear that there is a problem. If it works as it was explained > to me, then it doesn't sound like a big deal. > >> Ugh. Is there no way in LTE to avoid the blacklist problem? >> >>> On Oct 4, 2016, at 21:02, Adam Moffett <[email protected]> wrote: >>> >>> It was explained to me today by tech support that the CPE can blacklist >>> an eNB if it's unable to connect. They warned me about this possibility >>> when we were talking about site survey procedures. I.E.: if a >>> technician boots up the CPE while it's laying on the ground, it might >>> detect an eNB, fail to connect, then blacklist that eNB. They suggested >>> pointing it in the general direction before powering it up. >>> >>> I was told it shouldn't happen if you've successfully connected to that >>> eNB previously, but that you do need to reboot to clear the blacklist in >>> the CPE. >>> >>>> Does the Telrad system experience issues where when a CPE is low signal >>>> and disconnects it may find itself blacklisted until the CPE is rebooted? >>>> >>>> If so, is there a way around this so a customer does not have to reboot >>>> the CPE? >>>> _______________________________________________ >>>> Telrad mailing list >>>> [email protected] >>>> http://lists.wispa.org/mailman/listinfo/telrad >>> _______________________________________________ >>> Telrad mailing list >>> [email protected] >>> http://lists.wispa.org/mailman/listinfo/telrad >> _______________________________________________ >> Telrad mailing list >> [email protected] >> http://lists.wispa.org/mailman/listinfo/telrad > > _______________________________________________ > Telrad mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/telrad _______________________________________________ Telrad mailing list [email protected] http://lists.wispa.org/mailman/listinfo/telrad
