Ugh. Is there no way in LTE to avoid the blacklist problem?
> On Oct 4, 2016, at 21:02, Adam Moffett <[email protected]> wrote: > > It was explained to me today by tech support that the CPE can blacklist > an eNB if it's unable to connect. They warned me about this possibility > when we were talking about site survey procedures. I.E.: if a > technician boots up the CPE while it's laying on the ground, it might > detect an eNB, fail to connect, then blacklist that eNB. They suggested > pointing it in the general direction before powering it up. > > I was told it shouldn't happen if you've successfully connected to that > eNB previously, but that you do need to reboot to clear the blacklist in > the CPE. > >> Does the Telrad system experience issues where when a CPE is low signal and >> disconnects it may find itself blacklisted until the CPE is rebooted? >> >> If so, is there a way around this so a customer does not have to reboot the >> CPE? >> _______________________________________________ >> Telrad mailing list >> [email protected] >> http://lists.wispa.org/mailman/listinfo/telrad >> > > _______________________________________________ > Telrad mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/telrad _______________________________________________ Telrad mailing list [email protected] http://lists.wispa.org/mailman/listinfo/telrad
