Guys, I just uploaded a new version that features an additional sat c/n chart.
Enjoy Ulrich Bangert > -----Ursprungliche Nachricht----- > Von: [email protected] > [mailto:[email protected]] Im Auftrag von Ulrich Bangert > Gesendet: Samstag, 11. Juli 2009 09:47 > An: 'Discussion of precise time and frequency measurement' > Betreff: Re: [time-nuts] Stable Z38XX > > > Hi Said, > > not necessary to supply you with a list: Just start the > software and open the debug window. You will see all serial > communication action. With no device connected just the > commands will appeear one below the other. You can use the > "window hold" option of the debug window to defeat the scrolling. > > There is also a second option: If you supply ME a list of > commands that your devices understand then I can detect the > device type by the answer to *IDN? and ask the devices just > what they understand and leave everything else out. That is > the stategy that the software already uses to cover the > Z3801/5/15 and the GCRU. > > Best regards > Ulrich > > > -----Ursprungliche Nachricht----- > > Von: [email protected] > > [mailto:[email protected]] Im Auftrag von [email protected] > > Gesendet: Freitag, 10. Juli 2009 20:23 > > An: [email protected] > > Betreff: Re: [time-nuts] Stable Z38XX > > > > > > Hi Ulrich, > > > > any chance you could send me a list of commands you utility > > uses as a > > minimum command-set so I can cross-check against our > > Fury/FireFly GPSDO's? > > > > There are lots of folks on this list that have our units, and > > it would be > > great if we could get it up and running for our interface as > > an alternative > > to GPSCon. > > > > Thanks, > > Said > > > > > > In a message dated 7/10/2009 07:17:31 Pacific Daylight Time, > > [email protected] writes: > > > > Guys, > > > > after a lot of help coming from Australia (thank you Hal and > > Kit) there is > > a > > stable version of my Z38XX utility available. It handles the > > Z3801, the Z3805, the Z3815 and the GCRU. > > > > It is available from the usual place. Enjoy! > > > > Ulrich Bangert > > www.ulrich-bangert.de > > Ortholzer Weg 1 > > 27243 Gross Ippener > > > > > > _______________________________________________ > > time-nuts mailing list -- [email protected] > > To unsubscribe, go to > > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > and follow the instructions there. > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
