Ulrich, I'm trying to run this against a Fury and z38xx doesn't seem to
keep the 115200 baud setting, it just changes back to 57600.
Scott
On 07/11/2009 02:47 AM, Ulrich Bangert wrote:
Hi Said,
not necessary to supply you with a list: Just start the software and open
the debug window. You will see all serial communication action. With no
device connected just the commands will appeear one below the other. You can
use the "window hold" option of the debug window to defeat the scrolling.
There is also a second option: If you supply ME a list of commands that your
devices understand then I can detect the device type by the answer to *IDN?
and ask the devices just what they understand and leave everything else out.
That is the stategy that the software already uses to cover the Z3801/5/15
and the GCRU.
Best regards
Ulrich
-----Ursprungliche Nachricht-----
Von: [email protected]
[mailto:[email protected]] Im Auftrag von [email protected]
Gesendet: Freitag, 10. Juli 2009 20:23
An: [email protected]
Betreff: Re: [time-nuts] Stable Z38XX
Hi Ulrich,
any chance you could send me a list of commands you utility
uses as a
minimum command-set so I can cross-check against our
Fury/FireFly GPSDO's?
There are lots of folks on this list that have our units, and
it would be
great if we could get it up and running for our interface as
an alternative
to GPSCon.
Thanks,
Said
In a message dated 7/10/2009 07:17:31 Pacific Daylight Time,
[email protected] writes:
Guys,
after a lot of help coming from Australia (thank you Hal and
Kit) there is
a
stable version of my Z38XX utility available. It handles the
Z3801, the Z3805, the Z3815 and the GCRU.
It is available from the usual place. Enjoy!
Ulrich Bangert
www.ulrich-bangert.de
Ortholzer Weg 1
27243 Gross Ippener
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
