Magnus Danielson wrote:
Mark Sims wrote:
If the battery has not been replaced, you also get the warning
message about the config being lost... Just the 160 error usually
means the battery was replaced, but the system was not recalibrated
(or a glitch wiped the memory). Anyway, I always replace the battery.
The battery is not a NiCad. It is a AA sized (Tadiran) lithium cell.
Correct, I just recall incorrectly. I did not find the exact model,
but a similar.
When I replace it, I install a AA battery holder so the next guy
does not have to worry about soldering.
You can cut the leads to the cell at the battery and solder the
holder (or new battery) to the nubs so you don't have worry about
desoldering on a 4 layer board.
Or, if you happen to a dozen or so fully equipped Pace PRC-2000
($6000+ when new) rework stations in the spare bedroom, you can
desolder the old cell from the board.
BTW, if you happen to need a pretty much fully equipped Pace
PRC-2000 rework station (it slices, it dices, it makes Julian
fries)... contact me offline... as our British friends would say
they really are a sweet piece of kit...
Hmm.... Julian calender fries? Would be intersting to look at one of
those...
Cheers,
Magnus
See:
http://en.wikipedia.org/wiki/Julienning
For what was intended
Bruce
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
