Hi The thing I usually mess up is getting the check sum to pass through what ever com stuff I'm using.
Bob On May 30, 2010, at 7:13 AM, <[email protected]> wrote: > Mike, > It would still output data at 9600 moto bin(after sending @@Ci). I also tried > successfully to turn on the Hn string. > I'm doing something wrong, or there is something I'm not doing right.. > Thanks > Norm > ---- mike cook <[email protected]> wrote: >> Hi Norm, >> hmm. doc says that the command willl switch the port to 4800, so you >> should see no coherent data at all immediately that the command is >> executed. Were you still getting 9600 data without resetting the device? >> Would it respond to MBP commands after the @@Ci ? >> Mike >> >> Le 30/05/2010 11:04, [email protected] a écrit : >>> Hi all!! >>> Trying to get a gt+ setup(also tried one of my m12+t's) as a nmea receiver. >>> @@Ci does not work. Did form the string correctly. >>> Tried it with tac32, used Labview to send the hex string. >>> Receiver ignores it and continues to send moto bin at 9600.. >>> Any ideas?? >>> Want to use this for a balloon flight with aprs. Good news is that we want >>> to launch Friday, so it's not too pressing. >>> Norm n3ykf >>> >>> >>> _______________________________________________ >>> time-nuts mailing list -- [email protected] >>> To unsubscribe, go to >>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>> and follow the instructions there. >>> >>> >>> >>> >> >> >> >> >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
