Bob, I used Labview to see exactly what was being sent in hex. Been there, done that. Playing with hex on a serial bus can be aggravating.
BTW: there are a few good terminal programs that will let you do the hex thing and translate the output. Good for setting up a receiver. Have fun, Norm ---- Bob Camp <[email protected]> wrote: > Hi > > The thing I usually mess up is getting the check sum to pass through what > ever com stuff I'm using. > > Bob > > On May 30, 2010, at 7:13 AM, <[email protected]> wrote: > > > Mike, > > It would still output data at 9600 moto bin(after sending @@Ci). I also > > tried successfully to turn on the Hn string. > > I'm doing something wrong, or there is something I'm not doing right.. > > Thanks > > Norm > > ---- mike cook <[email protected]> wrote: > >> Hi Norm, > >> hmm. doc says that the command willl switch the port to 4800, so you > >> should see no coherent data at all immediately that the command is > >> executed. Were you still getting 9600 data without resetting the device? > >> Would it respond to MBP commands after the @@Ci ? > >> Mike > >> > >> Le 30/05/2010 11:04, [email protected] a écrit : > >>> Hi all!! > >>> Trying to get a gt+ setup(also tried one of my m12+t's) as a nmea > >>> receiver. @@Ci does not work. Did form the string correctly. > >>> Tried it with tac32, used Labview to send the hex string. > >>> Receiver ignores it and continues to send moto bin at 9600.. > >>> Any ideas?? > >>> Want to use this for a balloon flight with aprs. Good news is that we > >>> want to launch Friday, so it's not too pressing. > >>> Norm n3ykf > >>> > >>> > >>> _______________________________________________ > >>> time-nuts mailing list -- [email protected] > >>> To unsubscribe, go to > >>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > >>> and follow the instructions there. > >>> > >>> > >>> > >>> > >> > >> > >> > >> > >> _______________________________________________ > >> time-nuts mailing list -- [email protected] > >> To unsubscribe, go to > >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > >> and follow the instructions there. > > > > > > _______________________________________________ > > time-nuts mailing list -- [email protected] > > To unsubscribe, go to > > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > and follow the instructions there. > > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
