On Thu, Feb 10, 2011 at 3:16 PM, Larry McDavid <[email protected]> wrote: > Greetings! I am a new member of the mail list. I've been using a HP Z3801A > GPS-steered standard but have just acquired a Trimble Thunderbolt GPS > Disciplined Clock. > > I'm seeking a recommendation for a power supply for this Thunderbolt > receiver. There is much discussion about noise from some switching supplies > and the effect on phase noise of the 10 MHz output. The Thunderbolt manual > specifies the following supply and loads: > > +12 vdc 750 mA > + 5 vdc 400 mA > -12 vdc 10 mA
It's very easy to build a linear supply. A 24V center tap transformers, some diodes and caps and then those three terminal regulators -- ===== Chris Albertson Redondo Beach, California _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
