It would be easy to modify my GPSMonitor project to drive a pin with an alarm signal if the GPS has lost lock. What you do with that signal is up to you.
See the project page at http://www.ko4bb.com/Timing/GPSMonitor/ Didier KO4BB Sent from my Verizon Wireless BlackBerry -----Original Message----- From: David VanHorn <[email protected]> Sender: [email protected] Date: Fri, 21 Oct 2011 10:43:28 To: Discussion of precise time and frequency measurement<[email protected]> Reply-To: Discussion of precise time and frequency measurement <[email protected]> Subject: Re: [time-nuts] Sneaky Errors Playing with my A unit "Timex" (It takes a licking and keeps on ticking) I'm not getting a reliable unlock even at + or - 5V Once unlocked, it seems to need to be inside 1.2V before locking. That results in about 4 hz error, which would be ok for me. Is there a way to automatically turn off the output if the GPS is unlocked? ________________________________________ From: [email protected] [[email protected]] On Behalf Of Mark Sims [[email protected]] Sent: Thursday, October 20, 2011 9:39 PM To: [email protected] Subject: [time-nuts] Sneaky Errors 1 ppm at 10 MHz is 10 Hz. It's been quite a while since I tested it, but if I remember correctly, if the Tbolt OCXO is off that far the GPS won't lock and the failure will be rather obvious. The typical Tbolt oscillator has a DAC gain of 3.5 Hz/V. 10 Hz would be 3V of DAC offset. Lady Heather can determine your actual oscillator gain constant using the oscillator autotune function (& A from the keyboard). From that you can calculate the DAC offset required to get you 10 Hz of shift. Put the unit into manual DAC control mode and set the DAC voltage to what is needed to shift the freq that much. See if it locks... _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
