I had similar difficulties with my SR620. I rewired the cables to the power switch so that the "out" position now switches the power on and the "in" position switches the power off. This has worked for me in the last 4 years.
Ulrich Bangert > -----Ursprüngliche Nachricht----- > Von: [email protected] > [mailto:[email protected]] Im Auftrag von Robert LaJeunesse > Gesendet: Mittwoch, 10. Oktober 2012 23:06 > An: Discussion of precise time and frequency measurement > Betreff: Re: [time-nuts] Stanford RS620 Acting up > > > The SR620 I worked on was unused for a long time, and would > not turn on. Seems > the power switch was oxidized and would not self-clean. Had > to unmount it so I > could use chemical cleaners without getting any residue on > the case or PCB. > IIRC the whole front panel needed to be pulled to do that > (not too difficult). > Beware the SR620 is slightly unusual in that the transformer > is not switched, > but rather the DC supplies are. > > Bob L. > > ________________________________ > From: Eric Haskell <[email protected]> > To: Time Nuts <[email protected]> > Sent: Wed, October 10, 2012 4:59:51 PM > Subject: [time-nuts] Stanford RS620 Acting up > > My RS620 became difficult to start ... > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
