Dear Corby, Good morning. Thank you for the detailed instructions to bring the 5065A close to desired frequency. I couldn't have a cleaner explanation of the process.
Yesterday evening I tried adjusting the C field in small steps using a mixer, lpf and two oscillators setup as my current frequency counter is not able to resolve de small increments/decrements of frequency adjustment. Still I could detect the adjustments as I performed them. The response is quite fast. I have been told that these units are really stable compared to the small telecom Rb units. I heard a comment that the 5065A is even more stable than the new Symmetricom units using the X72 Rb module. Have you ever measured such differences in stability? Thank you. Regards, Edgardo Molina Dirección IPTEL www.iptel.net.mx T : 55 55 55202444 M : 04455 20501854 Piensa en Bits SA de CV Información anexa: CONFIDENCIALIDAD DE INFORMACION Este mensaje tiene carácter confidencial. Si usted no es el destinarario de este mensaje, le suplicamos se lo notifique al remitente mediante un correo electrónico y que borre el presente mensaje y sus anexos de su computadora sin retener una copia de los mismos. Queda estrictamente prohibido copiar este mensaje o hacer usode el para cualquier propósito o divulgar su en forma parcial o total su contenido. Gracias. NON-DISCLOSURE OF INFORMATION This email is strictly confidential and may also be privileged. If you are not the intended recipient please immediately advise the sender by replying to this e-mail and then deleting the message and its attachments from your computer without keeping a copy. It is strictly forbidden to copy it or use it for any purpose or disclose its contents to any third party. Thank you. On Oct 19, 2012, at 5:55 PM, cdel...@juno.com wrote: > Edgardo, > > You do use the C-field adjust to put a 5065A "On frequency". The Factory > values are a moot point after all these years! > > Just incrementaly adjust the c-field control in small steps while > observing the frequency comparison. > > The only thing that might happen is that you reach one end of the C-field > pot before getting to the frequency you want. > > If that is the case you will need to set the synthesizer switch to the > next value in the chart. (either up or down depending on which way you > ran out of room.) > > Then start over with the c=field adjustment. > > If you switch the synthesizer setting you will need to remove power > momentarily to reset the synthesizers lock indication circuit. Otherwise > pushing the logic reset button to get the green light wont work. > > Corby > ____________________________________________________________ > Woman is 53 But Looks 25 > Mom reveals 1 simple wrinkle trick that has angered doctors... > http://thirdpartyoffers.juno.com/TGL3141/5081da95575015a951151st02duc > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
