In step 2 is this my Lab Ref, or the SR620 ref out that is put into Ext Ref and Input A ?
Thomas Knox > Date: Mon, 12 Nov 2012 09:52:13 -0800 > From: [email protected] > To: [email protected] > Subject: Re: [time-nuts] SR620 software and adjustment > > Volker: > > This is the adjustment procedure that I used: > > Use the following adjustment sequence to get the frequency spot on: > > 1. Set the Cal jumper to Cal Enable > 2. Connect the reference to Ext Ref (rear) and Input A > 3. Switch the counter to Ext Ref > 4. Set the CalByte 50 for the best display (this is a very fine adjustement) > 5. Switch the counter to Int Ref > 6. Set the CalByte 4 for the best display (this adjustement is coarse, > optimize!) > 7. Set the Cal jumper to Cal Disable > > > The procedure can be found in the list archives and at Brooke Clarke's > website at: http://www.prc68.com/I/TandFTE.shtml > > -Eric > > > > On Mon, Nov 12, 2012 at 8:05 AM, Volker Esper <[email protected]> wrote: > > > > Sorry, I don't want to annoy you, but I can't find the alignment/adjustment > > procedure for the SR620 - once, I had it... :-( I don's mean that in the > > manual, there must be another one Bob talked about. > > > > By the way: is there any suitable vindous software out there, for talking > > (and listening) to the SR620 via RS-232? A program like Ulrichs Z38xx would > > be nice... > > > > Thanks a lot and please don't be annoyed - I guess this kind of question is > > not very inspiring. > > > > Volker > > > > > > _______________________________________________ > > time-nuts mailing list -- [email protected] > > To unsubscribe, go to > > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > and follow the instructions there. > > > > -- > --Eric > _________________________________________ > Eric Garner > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
