This is your Lab Ref Juerg Koegel
2012/11/12 Tom Knox <[email protected]>: > > In step 2 is this my Lab Ref, or the SR620 ref out that is put into Ext Ref > and Input A ? > > Thomas Knox > > > >> Date: Mon, 12 Nov 2012 09:52:13 -0800 >> From: [email protected] >> To: [email protected] >> Subject: Re: [time-nuts] SR620 software and adjustment >> >> Volker: >> >> This is the adjustment procedure that I used: >> >> Use the following adjustment sequence to get the frequency spot on: >> >> 1. Set the Cal jumper to Cal Enable >> 2. Connect the reference to Ext Ref (rear) and Input A >> 3. Switch the counter to Ext Ref >> 4. Set the CalByte 50 for the best display (this is a very fine adjustement) >> 5. Switch the counter to Int Ref >> 6. Set the CalByte 4 for the best display (this adjustement is coarse, >> optimize!) >> 7. Set the Cal jumper to Cal Disable >> >> >> The procedure can be found in the list archives and at Brooke Clarke's >> website at: http://www.prc68.com/I/TandFTE.shtml >> >> -Eric >> >> >> >> On Mon, Nov 12, 2012 at 8:05 AM, Volker Esper <[email protected]> wrote: >> > >> > Sorry, I don't want to annoy you, but I can't find the alignment/adjustment >> > procedure for the SR620 - once, I had it... :-( I don's mean that in the >> > manual, there must be another one Bob talked about. >> > >> > By the way: is there any suitable vindous software out there, for talking >> > (and listening) to the SR620 via RS-232? A program like Ulrichs Z38xx would >> > be nice... >> > >> > Thanks a lot and please don't be annoyed - I guess this kind of question is >> > not very inspiring. >> > >> > Volker >> > >> > >> > _______________________________________________ >> > time-nuts mailing list -- [email protected] >> > To unsubscribe, go to >> > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> > and follow the instructions there. >> >> >> >> -- >> --Eric >> _________________________________________ >> Eric Garner >> >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
