I figured that I had nothing to lose at this point, so I did a ":SYSTEM:PRESET". The date still seems to be correct, but now I have to wait until the GPS almanace is rebuilt and I get lock again. Hopefully, at that point, the strange firmware issues will go away :-)
Joe Gray W5JG On Sun, Jan 13, 2013 at 9:42 PM, Joseph Gray <[email protected]> wrote: > Well, it sort of worked. Now it won't come out of holdover. It's > telling me "1 PPS CLK Invalid: Time RAIM error". It also says "GPS > 1PPS CLK Invalid". > > Joe Gray > W5JG > > On Sun, Jan 13, 2013 at 9:28 PM, Joseph Gray <[email protected]> wrote: >> Forcing the date on power up worked, although a bit strangely. I >> entered "2013,01,14" and got an "out of range" error. The date then >> showed as "14 Jan 2007" briefly, before showing "14 Jan 2013". >> >> Joe Gray >> W5JG >> >> On Sun, Jan 13, 2013 at 9:17 PM, Joseph Gray <[email protected]> wrote: >>> I just tried manually putting the unit into holdover and setting the >>> date. Same error. I'll have to try power cycling. >>> >>> Joe Gray >>> W5JG >>> >>> On Sun, Jan 13, 2013 at 8:57 PM, Hal Murray <[email protected]> wrote: >>>> >>>> [email protected] said: >>>>> I did that command earlier, but got an error. I just tried it again and I >>>>> get the same error: >>>> >>>>> -221 "Settings conflict" >>>> >>>> I don't remember any troubles. I wasn't using anything complicated like >>>> SatStat. >>>> >>>> You might have to set the time when it doesn't know it. Try power cycling >>>> and set the time before it finds the satellites and time. >>>> >>>> >>>> -- >>>> These are my opinions. I hate spam. >>>> >>>> >>>> >>>> >>>> _______________________________________________ >>>> time-nuts mailing list -- [email protected] >>>> To unsubscribe, go to >>>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>>> and follow the instructions there. >>>> _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
