If you have a pdf manual, you probably have the same one I have. When I
was looking today, I did see that the input pin numbers listed in the
table, where it describes the programming (p 29 in the one I have or p32
of the pdf), does not match SCHEMATIC, PE-1121 (figure 7 or p44 of the
pdf). I think the schematic is not really for the 3200 as it doesn't
seem to show any inputs for the two GHz bits.
On 3/1/2013 4:37 PM, Iban Cardona wrote:
Hi Alan,
thanks for answer. Yes I have the manual, but the latches on my pts
not are as are showed in the user manual. Maybe my unit it is a
different version or release, or have some customozation from the pts
guys.
In myunit, I tested the SO-2005 module that is that generates the
100Mhz decade, and I tested manually the 4bit to generate the 800Mhz
and works well.
My unit dont have front panel, only can be controllated remotelly.
The differences from the user manual, is that un the user manual the
1ghz and 100mhz decade shares latch, and in my unit the shares latch
the 100mhz with the 10mhz. The 1ghz latch is shared by the 1hz decade.
Best regards
73! Iban
eb3frn
On Fri, Mar 1, 2013 at 8:27 PM, Alan Melia<alan.me...@btinternet.com> wrote:
Hi Iban do you have a manual? they are available. From memory because its a
while since I worked on my Wavetek- Rockland unit I believe the remote
programming is in parallel with the front panel switches. The reason for
raising this is that there may be a problem on the back of the panel
switches.....mabe a wire off. Does the 800Mhz front panel switch setting
work correctly ??
Alan
G3NYK
----- Original Message ----- From: "Iban Cardona"<icard...@gmail.com>
To:<time-nuts@febo.com>
Sent: Friday, March 01, 2013 6:42 PM
Subject: [time-nuts] PTS 3200 remote programming
Hi,
I'm traying to use to program the bcd interface of a PTS 3200.
My truble us tha the 100Mhz decade 8 value bit is ignored by the PTS,
then if I send 800Mhz to the PTS dont get output, and if send 900Mhz
then I get 100Mhz.
I checked the unit and the hardware looks OK. And my code is working
well in another PTS units like the 620.
The 3200 have some trick?
Thanks for all
73! Iban
eb3frn
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
