Ah, The old Section 2 part (in Don Adams voice)

Okay, I have been watching the timer out of the corner of my eye, and there is 
a trend.
The TI difference gradually falls down to about 3ns (good) then shoots up to 
103ns (bad) and then slowly falls down to 3ns in just over an hour, it then 
shoots up to 103ns again and repeats the process.

This is why I get good readings for short term.

The frequency can't be out that much, surely?

Anyway, as you say, Put it in the 9390 and see if 9390 can phase-lock it.

That certainly will be interesting if it does!


-marki


-----Original Message-----
From: time-nuts-boun...@febo.com [mailto:time-nuts-boun...@febo.com] On Behalf 
Of Ed Palmer
Sent: Thursday, 30 May 2013 3:31 AM
To: time-nuts@febo.com
Subject: Re: [time-nuts] 9390 GPS RX


On 5/29/2013 9:58 AM, Mark C. Stephens wrote:
> Uh, well. No one told me about the heatsink thing :)

Section 2 in the manual talks about mounting and heatsinking.  You mean you 
didn't read the flippin' manual??? ;)  Anyway, it's good that you were able to 
get it on frequency.

> I am using a HP5370B.
> I am comparing to my best GPSDO.
> For instance my 5x Z3805A's get down to the low -12's after 1 hour.

Remember what these measurements mean.  Result = sqrt(<measurement 
system>^2 + DUT^2 + Reference^2).  Your measurement system and reference
have to be significantly better than the DUT or they will affect the result.  
The 5370B should be low enough to be ignored at these Tau values.  Your Z3805A 
should be okay, I think, but not by much.  My Z3801A happens to have a 
'disciplining hump' that peaks at around 1000 sec. and was affecting the 
measurement at 800 sec.  I was also using a 5370B.

> 4.7e-11 at 1 hour 12 minutes.

Yeah, that's high considering that the monthly drift is supposed to be less 
than that!  Let it soak for a month and see what happens.

> Do you think the FRK is ready to go back in the 9390 :) I hope so, I 
> like that 9390 and I want it in my rack :)

Yes, I think so.  Like I said, see what monitoring capability the 9390 has.  I 
suspect that the FRK will improve over the next while. Only time will tell how 
much.

Congratulations!  It looks like your FRK is alive!  After a little time to work 
out the last few kinks it should be in good shape. (Knock on
wood!)  :)

Ed


_______________________________________________
time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to 
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.


_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to