Trying to catch up on several hundred work emails. Not exciting. I absolutely agree that the 60002 would make a lot of sense.
On Sat, Jun 22, 2013 at 1:19 AM, Burt I. Weiner <[email protected]> wrote: > Paul, > > This is probably why they sell crystals cut for 60,002 kHz and 60,005 kHz. > I ordered 10 of the 60,000 kHz crystals from DigiKey for about a buck > each. The 60,002 and 60,005 crystals were only available in lots of a > bazillion. It sounds like when I build the oscillator portion of the > remodulator I may to have to play a wee bit to get the new carrier within > tolerance of what the 8170 wants to see. > > Sorry to hear you've been fighting a flu bug. A lot of folks I know have > recently gone through a bought of the flu. I had it for a week but it was > mild compared to what some folks I know went through. I hope you're > feeling 100% real soon. > > Burt, K6OQK > > At 09:26 PM 6/21/2013, [email protected] wrote > >> Hello to the group >> Very good thread. I am recovering from a severe flu. Thats wgy I have not >> been around. >> This will be brief. >> 1Hz off seems to cause an issue. >> The 60 khz xtals from mouser all seem to always be low. >> So by lowering the drive and I assume loading. The 20K resistor they come >> into range. >> Don't like this and ordered a few xtals from china. Oh lets say 50. >> Nothing says a 6 mhz xtal and divider can't work. Just adds complexity and >> cost. >> By the way the MAS 6180 is available but the distro wants an order of 50 >> at >> $4 each. >> I can't take on the role of purchasing and distributing the chips. >> Regards >> Paul >> >> > Burt I. Weiner Associates > Broadcast Technical Services > Glendale, California U.S.A. > [email protected] > www.biwa.cc > K6OQK > ______________________________**_________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/** > mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts> > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
