See my update I think the xtals no longer going to be an issue
On Sat, Jun 22, 2013 at 10:17 AM, paul swed <[email protected]> wrote: > Trying to catch up on several hundred work emails. Not exciting. > I absolutely agree that the 60002 would make a lot of sense. > > > On Sat, Jun 22, 2013 at 1:19 AM, Burt I. Weiner <[email protected]> wrote: > >> Paul, >> >> This is probably why they sell crystals cut for 60,002 kHz and 60,005 >> kHz. I ordered 10 of the 60,000 kHz crystals from DigiKey for about a buck >> each. The 60,002 and 60,005 crystals were only available in lots of a >> bazillion. It sounds like when I build the oscillator portion of the >> remodulator I may to have to play a wee bit to get the new carrier within >> tolerance of what the 8170 wants to see. >> >> Sorry to hear you've been fighting a flu bug. A lot of folks I know have >> recently gone through a bought of the flu. I had it for a week but it was >> mild compared to what some folks I know went through. I hope you're >> feeling 100% real soon. >> >> Burt, K6OQK >> >> At 09:26 PM 6/21/2013, [email protected] wrote >> >>> Hello to the group >>> Very good thread. I am recovering from a severe flu. Thats wgy I have not >>> been around. >>> This will be brief. >>> 1Hz off seems to cause an issue. >>> The 60 khz xtals from mouser all seem to always be low. >>> So by lowering the drive and I assume loading. The 20K resistor they come >>> into range. >>> Don't like this and ordered a few xtals from china. Oh lets say 50. >>> Nothing says a 6 mhz xtal and divider can't work. Just adds complexity >>> and >>> cost. >>> By the way the MAS 6180 is available but the distro wants an order of 50 >>> at >>> $4 each. >>> I can't take on the role of purchasing and distributing the chips. >>> Regards >>> Paul >>> >>> >> Burt I. Weiner Associates >> Broadcast Technical Services >> Glendale, California U.S.A. >> [email protected] >> www.biwa.cc >> K6OQK >> ______________________________**_________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to https://www.febo.com/cgi-bin/** >> mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts> >> and follow the instructions there. >> > > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
