The programming of the ENET/100 has to be done with an older ver of Labview (7.1 IIRC), something that has no later than win 2k as an operating system. I had one of these and went through the setup of the ip address. Once it worked, it was like a hardware controller. (using LV 8.0)
On Wed, Nov 20, 2013 at 11:32 AM, Dr. David Kirkby <[email protected]>wrote: > On 20 November 2013 02:35, paul swed <[email protected]> wrote: > > Don > > A couple of comments. I have the old ethernet 100 also. As I recall it > > would only work up until windows 98 or 2000.. > > I don't think that is true > > http://www.ni.com/download/ni-488.2-3.1.2/4360/en/ > > supports windows 8 and supports both GPIB-ENET/100 > & GPIB-ENET/1000. > > > Dave > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
