[time-nuts] Lady Heather and the NTGS50AA

Sat, 18 Jan 2014 06:57:54 -0800

I have a NTGS50AA working with the Lady Heather last version which incorporate support for this board (Thanks Mask Sims). When I bought the board I used the Trimble utility GPS Monitor (GPSTM Commissioning Tool V1.5) to set it up and in the way knowing that it was previously working in Guatemala. This program uses COM1 or 2 with a fixed configuration of 19200, 7,Odd and 1stop bit. After using LH it seems that it changed the parameters to 9600.0.N,1 probably using an undocumented command and the board stores this configuration even if unpowered. But now I can't use the Trimble program because it refuses to connect, even it crashes when trying to connect at 19200 baud. Strangely it worked a couple of times when I was trying to command the leds in the panel but I don't know how it managed to change the baud rate. Does anybody know how to change the configuration of the board serial port, maybe an undocumented command? I have the manual but I don't find anything neither in the LH documentation. 

Regards,
Ignacio

_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to