Ignacio,
The "Strangely it worked a couple of times" maybe it has auto baud routine
that is active shortly after reset or power on.
Stanley
----- Original Message -----
From: "EB4APL" <[email protected]>
To: "Discussion of precise time and frequency measurement"
<[email protected]>
Sent: Saturday, January 18, 2014 8:27 AM
Subject: [time-nuts] Lady Heather and the NTGS50AA
I have a NTGS50AA working with the Lady Heather last version which
incorporate support for this board (Thanks Mask Sims).
When I bought the board I used the Trimble utility GPS Monitor (GPSTM
Commissioning Tool V1.5) to set it up and in the way knowing that it was
previously working in Guatemala. This program uses COM1 or 2 with a
fixed configuration of 19200, 7,Odd and 1stop bit. After using LH it seems
that it changed the parameters to 9600.0.N,1 probably using an
undocumented command and the board stores this configuration even if
unpowered. But now I can't use the Trimble program because it refuses to
connect, even it crashes when trying to connect at 19200 baud. Strangely
it worked a couple of times when I was trying to command the leds in the
panel but I don't know how it managed to change the baud rate.
Does anybody know how to change the configuration of the board serial
port, maybe an undocumented command? I have the manual but I don't find
anything neither in the LH documentation.
Regards,
Ignacio
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
