Oops, I meant Mark Sims, sorry.
Ignacio EB4APL
On18/01/2014 15:27, EB4APL wrote:
I have a NTGS50AA working with the Lady Heather last version which
incorporate support for this board (Thanks Mask Sims).
When I bought the board I used the Trimble utility GPS Monitor (GPSTM
Commissioning Tool V1.5) to set it up and in the way knowing that it
was previously working in Guatemala. This program uses COM1 or 2
with a fixed configuration of 19200, 7,Odd and 1stop bit. After using
LH it seems that it changed the parameters to 9600.0.N,1 probably
using an undocumented command and the board stores this configuration
even if unpowered. But now I can't use the Trimble program because
it refuses to connect, even it crashes when trying to connect at 19200
baud. Strangely it worked a couple of times when I was trying to
command the leds in the panel but I don't know how it managed to
change the baud rate.
Does anybody know how to change the configuration of the board serial
port, maybe an undocumented command? I have the manual but I don't
find anything neither in the LH documentation.
Regards,
Ignacio
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
