Hi Arthur, Found your original picture/post. TNX!
http://s906.photobucket.com/user/rjb1998/media/RFTG-uREF1photo1_zps87c505ca.jpg.html Would you share what you did for a 5 MHz buffer? Mike On 10/31/2014 10:20 PM, Arthur Dent wrote:
Bob Stewart bob at evoria.net “…I have both of my units sitting on the bench. I found that I needed to connect them together to get the REF1 unit to come out of standby….” Bob Camp kb8tq at n1k.org “I suspect that somebody will have to figure out what the 15 pin connector / jumper is doing. On previous RFTG units there was a way to re-wire the crossover interface to fake out the slave detect process. That would let you run a single GPS equipped box and have it behave correctly. Without the fake wires trick none of them played nice without the slave being present….” ++++++++++++++++++++++++++++++++++++++ Reposting what I had posted over a week ago, in case you missed it…. Arthur Dent golgarfrincham at gmail.com Wed Oct 22 13:59:48 EDT 2014 “…Way back on Fri Jun 11 16:48:43 UTC 2010 I posted about using one of these units I had modified but at the time there wasn't a single person who was interested. I have been using the RFTG-u REF1 since then and it is a nice unit. The modifications I added (including a power supply -see photo) allows the lights to cycle through their normal sequence on warm-up and the second unit isn't needed at all….” -Arthur _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
-- 73, Mike, N1JEZ "A closed mouth gathers no feet" _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
