For those who missed it, Arthur's post is at 
https://www.febo.com/pipermail/time-nuts/2010-June/047825.html and the photo is 
at 
http://i906.photobucket.com/albums/ac262/rjb1998/RFTG-uREF1photo1_zps87c505ca.jpg

Anthony




-----Original Message-----
From: time-nuts [mailto:[email protected]] On Behalf Of Arthur Dent
Sent: Friday, October 31, 2014 9:20 PM
To: [email protected]
Subject: [time-nuts] Lucent KS-24361, HP/Symmetricom Z3809A, Z3810A, Z3811A, 
Z3812A GPSDO system

Bob Stewart bob at evoria.net
 ?? ? I have both of my units sitting on the bench. I found that I needed to 
connect them together to get the REF1 unit to come out of standby ? . ??

Bob Camp kb8tq at n1k.org
 ??I suspect that somebody will have to figure out what the 15 pin connector / 
jumper is doing. On previous RFTG units there was a way to re-wire the 
crossover interface to fake out the slave detect process. That would let you 
run a single GPS equipped box and have it behave correctly. Without the fake 
wires trick none of them played nice without the slave being present ? . ??
++++++++++++++++++++++++++++++++++++++
Reposting what I had posted over a week ago, in case you missed it ? .

Arthur Dent golgarfrincham at gmail.com Wed Oct 22 13:59:48 EDT 2014  ?? ? Way 
back on Fri Jun 11 16:48:43 UTC 2010 I posted about using one of these units I 
had modified but at the time there wasn't a single person who was interested. I 
have been using the RFTG-u REF1 since then and it is a nice unit. The 
modifications I added (including a power supply -see photo) allows the lights 
to cycle through their normal sequence on warm-up and the second unit isn't 
needed at all ? . ??

-Arthur
_______________________________________________
time-nuts mailing list -- [email protected] To unsubscribe, go to 
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to