Hi > On Oct 31, 2014, at 10:20 PM, Arthur Dent <[email protected]> wrote: > > Bob Stewart bob at evoria.net > “…I have both of my units sitting on the bench. I found that I needed to > connect them together to get the REF1 unit to come out of standby….” > > Bob Camp kb8tq at n1k.org > “I suspect that somebody will have to figure out what the 15 pin > connector / jumper is doing. On previous RFTG units there was a > way to re-wire the crossover interface to fake out the slave detect > process. That would let you run a single GPS equipped box and have > it behave correctly. Without the fake wires trick none of them > played nice without the slave being present….” > ++++++++++++++++++++++++++++++++++++++ > Reposting what I had posted over a week ago, in case you missed it…. > > Arthur Dent golgarfrincham at gmail.com Wed Oct 22 13:59:48 EDT 2014 > “…Way back on Fri Jun 11 16:48:43 UTC 2010 I posted about using one of > these units I had modified but at the time there wasn't a single person > who was interested. I have been using the RFTG-u REF1 since then and > it is a nice unit. The modifications I added (including a power supply > -see photo)
It’s the “see photo” part that I was having a hard time with. For what ever reason, the link in your original post did not work for me. Bob > allows the lights to cycle through their normal sequence > on warm-up and the second unit isn't needed at all….” > > -Arthur > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
