So that's it folks, after all this it would now seem that all that's
needed to enable a Ref-1 unit stand alone is to link together J5 pins 2, 10, 12,
and 15, and to ground pin 3 to pin 8, and then just hang around for hours
and hours on end with yer fingers crossed:-)
I don't know if it's possible to monitor the J8 Diagnostic port whilst
waiting for it come live, that would at least give a better idea of what's
going on, but I deliberately avoided any other connections whilst trying this
out so it's possible that might be inhibited also.
Anyway, apologies for all the waffle, I've been topping this up as I go
along whilst surviving on coffee and getting a bit groggy in the process,
it's 0730 here now and no sleep yet, but once I'd had my first encouraging
results there was no way I could just go to bed and leave it:-)
Regards
Nigel
GM8PZR
------------------------
I connected pin 4 also to ground permantly without observing any
negative sideeffects. SDo no active electrics needed but you will (want
?!) not see STBY led blinking.
Götz
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
