Hi Anthony,
I was getting that error, then "communication established", then some rapid
fire procession of error messages that I didn't write down, then back to
"trying to establish communication". It's probably something simple like a bad
cap, but it was still under warranty, so not my problem.
Bob
From: Anthony Roby <[email protected]>
To: Discussion of precise time and frequency measurement <[email protected]>
Sent: Friday, November 7, 2014 2:18 PM
Subject: Re: [time-nuts] Lucent KS-24361 GPSDO arrived today several questions
I have both versions of SatStat (the HP and the Symmetricon). Both are set for
COM1 9660, 8, n, 1. Both are running in an XP VM. I have tested the
virtualized to physical COM1 connection using a terminal program and a scope,
so I know that works. When I select Port Open, I just get "Trying to establish
communication". I never see the SatStat info page.
If I use the terminal program under XP or on the Win7 host, I can send *IDN? ,
:SYST:STAT? etc. but never get a response. Although I can see a response by
scoping the cable - it peaks around 4.5v, and is quite noisy. My suspicion is
that it's the noise that is causing the trouble. AECI are sending me
replacement units, but if you have any ideas of other things to try, let me know
Thanks
ANthony
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
