Like to confirm
It has been said ...
>When you apply power, all the LEDs on the front panel will flash. The
>"NO GPS" light will continue flashing until you connect a GPS antenna.
>Once it sees a satellite, the light will stop flashing and remain on.
>The unit will conduct a self-survey for several hours. Eventually, if
>all is well, the Z3812A ("REF 0" on its front panel) will show one
>green "ON" light and the Z3811A ("REF 1") will show one yellow "STBY"
>light. This means that the Z3812A is actually transmitting its 15MHz
>output, and the other one is silently waiting to take over if it
>fails.
Is this correct about the "NO GPS" LED ?
Once the survey is over, and the GPS is considered to be "GOOD", should
the yellow NO GPS LED be lit ?
For me after being on for a while the LED for me are
REF 1
NO GPS ON solid - this is the one I'm asking about
Fault OFF
STBY ON
ON OFF
REF 0
NO GPS ON
FAULT OFF
STBY OFF
ON ON
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
