Hi I think having the connectors on hand for a new cable is a real good idea…..
Bob > On Nov 16, 2014, at 3:53 PM, Pete Lancashire <[email protected]> wrote: > > ... LED goes out ... I though so but just wanted to make sure. I've > purchased a 2nd set and will see how that behaves. Also ordered a few > of the DE-15 (if that is the correct way of saying it) connectors. The > short pin concept seems to have not been a great idea. > > -pete > > On Sun, Nov 16, 2014 at 12:40 PM, Bob Camp <[email protected]> wrote: >> Hi >> >> On all my box pairs, the “NO GPS” lights all go out on all boxes once >> everything is “GOOD” as you define it. A properly operating pair will have >> a STBY light (and only that light) on one box. The other box will have only >> the ON light lit. >> >> Based on what I’ve seen. I’d suspect the cable between the two units as the >> source of (almost) any problem before I’d dig into the rest of the system. >> >> Bob >> >>> On Nov 16, 2014, at 3:29 PM, Pete Lancashire <[email protected]> >>> wrote: >>> >>> Like to confirm >>> >>> It has been said ... >>>> When you apply power, all the LEDs on the front panel will flash. The >>>> "NO GPS" light will continue flashing until you connect a GPS antenna. >>>> Once it sees a satellite, the light will stop flashing and remain on. >>>> The unit will conduct a self-survey for several hours. Eventually, if >>>> all is well, the Z3812A ("REF 0" on its front panel) will show one >>>> green "ON" light and the Z3811A ("REF 1") will show one yellow "STBY" >>>> light. This means that the Z3812A is actually transmitting its 15MHz >>>> output, and the other one is silently waiting to take over if it >>>> fails. >>> >>> Is this correct about the "NO GPS" LED ? >>> >>> Once the survey is over, and the GPS is considered to be "GOOD", should >>> the yellow NO GPS LED be lit ? >>> >>> For me after being on for a while the LED for me are >>> >>> REF 1 >>> NO GPS ON solid - this is the one I'm asking about >>> Fault OFF >>> STBY ON >>> ON OFF >>> REF 0 >>> NO GPS ON >>> FAULT OFF >>> STBY OFF >>> ON ON >>> _______________________________________________ >>> time-nuts mailing list -- [email protected] >>> To unsubscribe, go to >>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>> and follow the instructions there. >> >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
