Hi Matt, Any of the AMP Service Tools - I have the I and II - will work. Positions A and B (for the conductor and the insulation respectively) on Service Tool I or E and B on Service Tool II will work nicely. I suspect there are lots of other "generic" crimpers that will do the job as well. Heck, for just one connector, needle-nose pliers, a good magnifier, a soldering iron, and a dictionary of curse words will suffice... ;-)
Good luck. 73, geo - n4ua On Mon, Jun 8, 2015 at 6:29 AM, Matt Robert <matt.rob...@gmail.com> wrote: > Hi Guys, > > I am currently in the process of completing my Thunderbolt project and I > need to find a suitable crimper to attach wires to the pins that go inside > the power connector. > > The only reference I can find is on this page here ( > http://www.prc68.com/I/ThunderBolt.shtml) that talks about the official > Molex tool which is scarily expensive, and the page also mentioned a > Radioshack tool that I can't find any further details on. > > Can someone please point me in the right direction of a suitable crimper > for the Molex 538-16-02-0103 pins. > > Cheers, > Matt > VK2LK > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.