The PA-09 crimp tool will do a lot of smaller crimps, even the small JST sizes. There's also a bigger one available.
http://www.ebay.co.uk/itm/261046260247?ru=http%3A%2F%2Fwww.ebay.co.uk%2Fsch%2Fi.html%3F_nkw%3D261046260247%26_rdc%3D1 On Mon, Jun 8, 2015 at 12:53 PM, George Dubovsky <[email protected]> wrote: > I had not realized that those ubiquitous AMP crimpers of yore were now ebay > curiosities, but this is what I was referring to in my earlier e-mail: > > < > > http://www.ebay.com/itm/Amp-Engineer-Service-Tool-II-Crimper-/231586917342?pt=LH_DefaultDomain_0&hash=item35eba7ebde > > > > 73, > > geo - n4ua > > On Mon, Jun 8, 2015 at 7:44 AM, George Dubovsky <[email protected]> wrote: > > > Hi Matt, > > > > Any of the AMP Service Tools - I have the I and II - will work. Positions > > A and B (for the conductor and the insulation respectively) on Service > Tool > > I or E and B on Service Tool II will work nicely. I suspect there are > lots > > of other "generic" crimpers that will do the job as well. Heck, for just > > one connector, needle-nose pliers, a good magnifier, a soldering iron, > and > > a dictionary of curse words will suffice... ;-) > > > > Good luck. > > > > 73, > > > > geo - n4ua > > > > On Mon, Jun 8, 2015 at 6:29 AM, Matt Robert <[email protected]> > wrote: > > > >> Hi Guys, > >> > >> I am currently in the process of completing my Thunderbolt project and I > >> need to find a suitable crimper to attach wires to the pins that go > inside > >> the power connector. > >> > >> The only reference I can find is on this page here ( > >> http://www.prc68.com/I/ThunderBolt.shtml) that talks about the official > >> Molex tool which is scarily expensive, and the page also mentioned a > >> Radioshack tool that I can't find any further details on. > >> > >> Can someone please point me in the right direction of a suitable crimper > >> for the Molex 538-16-02-0103 pins. > >> > >> Cheers, > >> Matt > >> VK2LK > >> _______________________________________________ > >> time-nuts mailing list -- [email protected] > >> To unsubscribe, go to > >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > >> and follow the instructions there. > >> > > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
