In your image ...125 it looks like there is a cold solder joint near the bottom right, in the second "column" of pads, 3 pads up from the bottom.
On Mon, Oct 16, 2017 at 4:10 PM, Vlad <[email protected]> wrote: > > Hello, > > I am wandering if anybody observe the behavior for OCXO, when its stop to > reproduce the signal, and the only way to return it back to business is > little mechanical stress. > > I have TWO of such OCXO. One of them is Austron 11.2 Mhz. And another one > is Vectron model 218Y4442 9.8304Mhz > > In case with Vectron, I even disassemble it (to whom who brave here is a > pictures): > > http://www.patoka.ca/Vectron-218Y44442/ > > Then as I connect it to the PS, I realize it start to reproduce the signal > again ! Before this it was nothing ! I tried different PS before to open > this "can" as a last resort. > > For the Austron - I didn't disassemble it. Instead I just kick it a little > bit. And immediately after that, it start to produce the signal ! > > > -- > WBW, > > V.P. > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/m > ailman/listinfo/time-nuts > and follow the instructions there. > -- --Jim Harman _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
