Bob With a 1V p-p sort of output, a simple matching network will get you into the 4 to 6V p-p range. Drive that into a 5V compatible CMOS gate and move on …. If you have a super hot output, put a 3 db pad on it.
Bob > On Jan 19, 2018, at 5:40 PM, Tom Van Baak <[email protected]> wrote: > >> Tom >> What's the input signal amplitude? >> What's the desired output signal (eg 5V CMOS, 3.3V CMOS etc)? >> Bruce > > It's for a typical 5 or 10 MHz OCXO / Rb / Cs with sinewave output; say, 1 > Vpp. The output should be 3.3 or 5 V depending on what the MCU needs. It > doesn't have to have stunning performance: think breadboard, PIC, Arduino > sort of stuff. I was looking for something in a PDIP-8 package; the same as > all the picDIV or picPET chips I use. That's why older parts like µA9637 / > DS9637 came to mind. > > /tvb > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
